Preparation - Bosch GRL 500 H Consignes De Fonctionnement/Sécurité

Charging the Batteries of the
Measuring Tool and Laser
Receiver (see figures A – B)
Do not use a different battery charger. The
battery charger provided is matched to the
lithium-ion battery installed in your measuring
tool.
Observe the mains voltage! The voltage of
the power source must correspond with the
data on the type plate of the battery charger.
The measuring tool and
!
WARNING
laser receiver must be
charged only in dry indoor areas. The
charging cable is not permitted for charging
outdoors or in moist environments.
Note: The batteries of the measuring tool
and laser receiver are supplied partially
charged. To ensure full capacity of the
batteries, completely charge the batteries
before the first use.
The lithium-ion battery can be charged at
any time without reducing its service life.
Interrupting the charging procedure does not
damage the battery.
Charge-control Indicator
The measuring tool must be switched on
(see "Switching On", page 20) to display the
battery charge status of the measuring tool
and laser receiver.
Display
Indications Meaning
29
Battery fully
charged.
30
29
Battery partially
charged.
30
29
Battery partially
charged.
30
29
Battery partially
charged.
30
29
Battery should
be recharged.
30
If the measuring tool is switched off and
the laser receiver is in the charging/storage
station 6, the battery charge status can be
displayed as follows:
2610A16816.indd 18

Preparation

Remaining
measuring
Capacity time, approx.
60–100 % 15–25 h
40–60 % 10–15 h
20–40 % 5–10 h
10–20 % 2.5–5 h
0–10 % 0–2.5 h
-18-
Press the sleep mode button 21
until the audio signal sounds.
The battery charge-control
indicators 29 and 30 are displayed.
The display illumination switches off again
after 5 s.
Battery Charging
– Clean soiled charger contacts using a dry
cloth.
– Plug the charge connector 51 into the
socket provided on the charger 49.
The measuring tool can be recharged
independently of the laser receiver, but the
laser receiver can only be recharged together
with the measuring tool. The measuring tool
and the laser receiver cannot be used during
the charging process.
Measuring tool (see figure A):
– Open the cover 11 of the charge socket 14.
– Plug the power plug 52 of the power
supply into the socket outlet and the
charge connector 50 into the charge
socket 14.
Laser Receiver (see figure B):
– Slide the laser receiver into the charging/
storage station 6.
– Open the cover 11 of the charge socket 14.
– Plug the power plug 52 of the power
supply into the socket outlet and the
charge connector 50 into the charge
socket 14.
Display
Indications Meaning
29 Battery charging
30 The segments flash successively
during charging
The measuring tool and the laser receiver will
switch off after charging.
Disconnect the battery charger from the
measuring tool when not using it for longer
periods.
Protect the battery charger against
moisture!
/
11/13/15 1:12 PM