Oceanic OCEACLIM120W0 Manuel De L'utilisateur page 100

Operation
Water drainage
- During dehumidifying modes, remove the upper drain plug from the back of the unit, install the
drain connector (5/8" universal female mender) with 3/4" hose (locally purchased). For the models
without drain connector, just attach the drain hose to the hole. Place the open end of the hose
directly over the drain area in your basement floor.
- During heating pump mode, remove the lower drain plus from the back of the unit, install the
drain connector (5/8" universal female mender) with 3/4" hose (locally purchased). For the models
without drain connector, just attach the drain hose to the hole. Place the open end of the Hose
adaptor directly over the drain area in your basement floor.
Note: Make sure the hose is secure so there are no leaks. Direct the hose toward the
drain, making sure that there are no kinks that will stop the warter flowing. Place the
C
end of the hose into the drain and make sure the end of the hose is down to let the
water flow smoothly. (See figs with
continuous drain hose is not used, ensure that the corresponding drain plug and knob
are installed firmly to prevent leakage.
98
Remove the upper
drain plug
Continuous drain
hose
. Do never let it up. (See figs with
Remove the lower
drain plug
Continuous drain hose
drain hose adaptor
). When the