Maintenance - Ryobi Tek4 HP53L Manuel D'utilisation

ADJUSTABLE TORQUE CLUTCH
This screwdriver is equipped with an adjustable torque clutch
for driving different types of screws into different materials.
The proper setting depends on the type of material and the
size of screw you are using.
ADJUSTING TORQUE
See Figure 6, page 9.
There are twenty-four torque indicator settings located on
the front of the screwdriver.
 Select the gear train setting to high (Position 2) or low
(Position 1) speed.
 Rotate the adjusting ring to the desired setting.
• 1 - 4 For driving small screws (Position 1 or 2)
• 5 - 8 For driving screws into soft material
(low speed - Position 1))
• 9 - 12 For driving screws into soft and hard
materials (low speed - Position 1)
wARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
wARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1 during maintenance. If operation
is dusty, also wear a dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
wARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
OPERATION
• 13 - 16 For driving screws into hard wood
• 17 - 24 For driving large screws
NOTE: During use, if the screwdriver stalls and begins to
make a clicking sound, and the LED worklight pulses on
and off, you should release the switch trigger immediately.
This indicates that you have overloaded the tool. Depress
the switch trigger again to resume operation.
To avoid this situation, avoid forcing the tool and refer to
the settings described above to be sure you are using the
screwdriver for its intended application.
LED wORkLIGHT
See Figure 7, page 9.
The screwdriver has a built-in LED worklight. This feature
is convenient when working in close or tight areas where
additional light is needed. Whenever the switch trigger is
depressed, the LED worklight will illuminate.

MAINTENANCE

STORAGE
Before storing, always remove the battery pack from the
battery compartment.
BATTERy PACk PREPARATION FOR
RECyCLING
wARNING:
Upon removal, cover the battery pack's terminals with
heavy-duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its compo-
nents. Lithium-ion batteries must be recycled or disposed
of properly. Also, never touch both terminals with metal
objects and/or body parts as short circuit may result.
Keep away from children. Failure to comply with these
warnings could result in fire and/or serious injury.
(ILLUSTRATIONS) START ON
PAGE 9 AFTER FRENCH AND
SPANISH LANGUAGE SECTIONS.
8 — English
(low speed - Position 1)
(low speed - Position 1)
NOTE: FIGURES