VOLTCRAFT 23 87 82 Notice D'emploi page 49

Call the item "SERVO TESTER" in the menu structure
and activate the selection with "ENTER".
The display shows the servo test function, with manual
testing already highlighted with a black background and
activated.
Now you can set the servo lever in any position with the
setting wheel for the servo test function (see figure 12,
item 4).
Additionally, the currently set servo control impulse
width is displayed. The value can be adjusted from
700 - 2300 μs.
Press the button "MODE" to change the display from
"Manual:" to "Auto:" The servo will now run indepen-
dently from one end stop to the other.
If the button "MODE" is pressed again, the 7 in 1
multimeter switches back to manual function.
Use the "BACK/ESC" button to exit the servo test
Figure 13
function and return to the menu structure.
49