Rear Spacers; Door Reversibility - AEG A62710GNW1 Notice D'utilisation

9.4 Rear spacers

You can find the two spacers in the bag
with documentation.
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
4
9.5 Levelling
Accurate levelling prevents the vibration
and noise of the appliance during
operation.
To adjust the heigh of the appliance
loosen or tighten the two adjustable
front feet.

9.6 Door reversibility

WARNING!
Before carrying out any
operations, remove the plug
from the power socket.
2
1
3
CAUTION!
To carry out the following
operations, we suggest that
this be made with another
person that will keep a firm
hold on the doors of the
appliance during the
operations.
1. Tilt back the appliance carefully so
that the compressor cannot touch
the floor.
2. Remove the plinth (1).
3. Remove the cap (2) and position it on
the opposite side.
4. Unscrew the hinge (3) and remove
the door.
3
5. Unscrew the lower pin and the
washers (3).
6. Position the pin and the washers (6)
on the opposite side (7).
7. Unscrew the other hinge (5).
6
8. Unscrew the upper pin (4) and screw
it on the opposite side (5).
ENGLISH 65
2
1
7
8