Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
32
6.2
DOOR REMOVAL / INSTALLATION
EN
IF EQUIPPED WITH DOOR LATCHES THAT ARE PART OF A SAFETY RELIEF SYSTEM, THEY MUST BE
PROPERLY ENGAGED. DO NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRE OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
DO NOT INSERT FINGERS IN THE GAP BETWEEN THE DOOR AND THE FRAMING EDGE, THERE IS A RISK OF
Before the glass door can be removed the safety screen
must be removed, refer to "SAFETY SCREEN REMOVAL /
INSTALLATION" section.
A.
Locate the door latches: one at each the left and
right side of the door between the main door and
framing edge.
B.
Place the latch key into slots of the door latch.
Pull out and forward to disengage door latches.
C.
Tilt the top of the door forward until you can grip the
sides of the door. Lift up and out of the bottom door
retainer.
D.
To re-install the door, lift onto the bottom door
retainer, pivot the top of the door into the closed
position. Hold the door in place and re secure the
latches. NOTE: These latches make up the spring
relief system for the appliance. Ensure they open
freely and close sealed.
Reverse these steps to re-install the door and trim with
safety screen. Ensure the safety screen is installed correctly.
6.3
BURNER INSTALLATION
See separate instructions accompanying burner assembly (sold separately).
W415-2201 / A / 12.14.16
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
INJURY DUE TO THE SPRING MECHANISM.
WARNING
!
WARNING
!
IMPORTANT: Once latches are engaged,
test to make sure that the door is secure
75.1A
Door Latch
and will not fall forward.
Publicité
Chapitres
Table des Matières
