Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING
!
•
Power supply service must be completed prior to finishing to avoid reconstruction.
•
Heat vents and air openings cannot be covered in any circumstances.
4.1
glass door removal and installation
WARNING
!
•
Glass may be hot. Do not touch glass until cooled.
•
If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
•
Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
•
Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
Remove the 4 screws off the appliance, as shown.
A.
Remove the glass front and place on a soft non-abrasive
B.
surface.
Reverse these steps to reinstall the glass front.
C.
4.2
placing glass media
Remove glass door, see "GLASS DOOR
A.
REMOVAL AND INSTALLATION" section.
Sprinkle glass media evenly onto PVC tray.
B.
Ensure glass media stays within the media tray
cavity.
NOTE : Extra glass media supplied. Use only
desired amount.
Do not allow children near glass media.
4.0 finishing
finishing
47.1
SCREW
W415-1662 / C / 07.20.20
EN
15
Publicité
Chapitres
Table des Matières
