19.The operator must check to be certain that every part of the tractor and,
especially the safety devices, are in good working condition and work to
specs. They should be kept in perfect working condition. If you note any
malfunctioning, fix or repair them in good time. If necessary contact your
nearest Assistance Centre. Failure to observe these instructions releases
manufacturer from all liability.
Pay special attention to the stickers on the machine.
Fig. 8: refer to this Operating and Maintenance Manual.
2. CONTROLS AND INSTRUMENTS
See fig.1
1 Engine stop lever (motorstop)
2 PTO lever
3 Gear lever
4 Handlebar horizontal adjustment lever
5 Throttle lever
6 Clutch lever
7 Wheel release lever
8 Handlebar vertical release lever
See fig.2
9 Left wheel release lever
10 Right wheel release lever
For models with electric starter:
See fig.9
11 Ignition switch
12 Light switch
13 Red generator warning light (off when engine has started)
See fig.11
14 Single-pole power socket.
3. MODEL IDENTIFICATION
Model, series and chassis number are the machine's identification data. They
are shown on a specific plate located on the accessory box or on the battery
housing.
4. OPERATING INSTRUCTIONS
4.1 STOPPING AND STARTING THE ENGINE
To start the engine, the Motorstop level B fig.3 must be locked all the way down.
pull the clutch disengage lever C and insert retainer A under the lever so that the
clutch is kept disengaged. In this way, both levers are locked to prevent the
44