Haussmann 02325006 Guide De L'utilisateur page 10

· Maintain Hedge Trimmer With Care – Keep cutting edge sharp
and clean for best performance and to reduce the risk of injury.
Follow instructions for lubricating and changing accessories.
Inspect hedge trimmer cord periodically, and if damaged, have
it repaired by an authorized service facility. Inspect extension
cords periodically and replace if damaged. Keep handles dry,
clean, and free from oil and grease.
· Check Damaged Parts – Before further use of the hedge
trimmer, a guard or other part that is damaged should be
carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of parts,
mounting, and any other condition that may affect its operation.
A guard or other part that is damaged should be properly
repaired or replaced by an authorized service center unless
indicated elsewhere in this manual.
Table A
Volts
Ampere rating
120 V
more than not more than
0 0
6 10
10 12
12 16
NOTE - Only the applicable parts of the Table need to ba included.
Figure A:
Method of securing cord set
CORN APPLIANCE
SET CORN
(A) THE CORN AS SHOWN
Hedge trimmer safety rules
The Hedge Trimmer must not be used by anyone under
the age of 16 or untrained person.
Keep children, other people and pets away from the
trimmer.
Always dress properly. Don't wear loose clothing or
jewellery; they can be caught in moving parts. Use of
rubber gloves and substantial footwear is recommended
when working outdoors. Wear protective hair covering to
contain long hair.
Use face dust mask if operation is dusty.
Do not use the trimmer if the cutting device is not
secured properly or is damaged.
Before starting the trimmer, make sure that the cutting
blade is not touching stones or debris.
When the trimmer is in operation, keep the cutting
section away from all parts of the body.
Do not cut against hard objects. This could cause injury
or damage the trimmer.
10
Total length of cord in feet
25 50 100 150
AWG
18 16 16 14
18 16 14 12
16 16 14 12
14 12 Not Recommended
(B) CONNECT PLUG AND RECEPTACLE
S1036A
Only cut during broad daylight or with corresponding
artificial light.
Don't abuse cord, never carry hedge trimmer by cord or
yank it to disconnect from receptacle. Keep cord from
heat, oil, and sharp edges.
When the trimmer is not in use, store it in a dry place so
that the blade is not exposed and out of the reach of
children.
The main voltage must correspond to the one marked on
the technical data plate. Do not use other sources of
power.
Never use the trimmer when it is raining. Try to prevent it
from getting wet or being exposed to humidity. Do not
leave it outside overnight. Do not cut damp or wet grass.
The power supply cable should be checked regularly.
Before each use, make sure cable is not damaged or
worn. If the cable is not in good condition, do not use the
trimmer. Take it to an authorized service center for proper
repair.
Only use an extension cord which is suitable for out door
work. Keep it away from the cutting area, damp, wet or
oily surfaces, or sharp edges. Keep away from heat and
fuels.
Avoid unintentional starting. Don't carry plugged in hedge
trimmer with fingers on both switches. Be sure switch is
off when plugging in.
Do not attempt to remove cut material or hold material to
be cut when blades are moving. Make sure trimmer
switch is off when clearing jammed material from blades.
Do not grasp the exposed cutting blades or cutting edges
when picking up or holding the hedge trimmer.
CAUTION: Blades coast after turn off.
!
Don't force hedge trimmer, it will do the job better and with
less likelihood of risk of injury at the rate for which it was
designed.
Stay alert, watch what you are doing. Use common
sense. Do not operate hedge trimmer when you are tired.
Maintain hedge trimmer with care, keep cutting blades
sharp and clean for best performance and to reduce the
risk of injury. Inspect extension cord periodically and
replace if damaged. Keep handles dry, clean and free
from oil and grease.
Use of a residual current device with a tripping current of
30 mA or less is required for machines for outdoor use.