Electrical Characteristics - AERMEC Novatherm GLLI10N Mode D'emploi

IR CONNECTION (THERMOSTAT RECEIVER)
The display card will physically connect to the GLLI_N
control box through a 4-pole cable as shown above
ELECTRIC CONTROL BOARD INPUT/OUTPUT:
The following tables illustrate the input/output of the control board (including for subsequent, non-FCL models). In the Input/output
column, the input/output is indicated, as per the control board wiring diagram, whereas the Function column indicates how the
inputs and outputs are used on the various machines onto which the control boards will be installed. Finally, the Electrical Features
column indicates the type of electrical signal that characterises the input/output.
I/O
M2
M1
M3
M4 AUX/RE: output for the electric heater command
M5 Neutral reference for the AUX/RE and MA output
M6
M7
M8
M9
M10
M11
M12
M13
M14
M26
M22
CN2
CN1
CN3
M15, M16
M17
M18
M19
M20
M21
M25
M27,M28
Function
L: Power supply input to the card
N: Power supply input to the card
GND: ground reference
MA: output for the fin motor command
Y2: output for the water valve command
Y1: output for the water valve command
Neutral reference for the Y1, Y2 output
Neutral reference for the V1, V2, V3 output
V3: maximum speed output
V2: average speed output
V1: minimum speed output
back-up input, not connected
Service control board
Control board for connection to receiver
SW: water probe
SA: air probe
SC: auxiliary water probe
SR: electric heater temperature probe
Out 0-10V: reference for inverter
GND of inverter reference
Out 0-10V
GND
Input for fault inverter reading
Expansion connector
CC: Condensate discharge motor fault input
4-PIPE PROBE CONNECTOR CONNECTION

Electrical characteristics

Voltage: 230V AC, current 10 A
Voltage: 230V AC, current 10 A
Voltage: 230V AC, current 10 A
Voltage: 230V AC, current 7 A
Voltage: 230V AC, current 5 A
Voltage: 230V AC, current 5 A
Voltage: 230V AC, current 5 A
Voltage: 230V AC, current 10 A
Voltage: 230V AC, current 10 A
Voltage: 230V AC, current 5 A
Voltage: 230V AC, current 5 A
Voltage: 230V AC, current 5 A
Voltage: 10 DC, current 10 mA
Voltage: 10 DC, current 10 mA
Voltage: 10 DC, current 10 mA
Voltage: 10 DC, current 10 mA
Voltage: 10 DC, current 10 mA
Voltage: 5 DC, current 0.5 mA
//
//
See figure 9
//
NTC 10Kohm
NTC 10Kohm
NTC 10Kohm
NTC 4Kohm 200°C
//
33