Troubleshooting; Disposal - Dometic Waeco CoolMatic FC40 Notice D'utilisation

Masquer les pouces Voir aussi pour Waeco CoolMatic FC40:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33

Troubleshooting

9
Troubleshooting
Fault
The device does not
work.
When operating from
the 12/24 V socket
(cigarette lighter):
The ignition is on and
the device is not work-
ing.
Pull the plug out of the
socket and make the
following checks.
10

Disposal

➤ Place the packaging material in the appropriate recycling waste bins
wherever possible.
M
If you wish to finally dispose of the product, ask your local recycling
centre or specialist dealer for details about how to do this in
accordance with the applicable disposal regulations.
30
Possible cause
There is no voltage pre-
sent in the 12/24 V
socket (cigarette lighter)
in the vehicle.
No voltage present in
the AC voltage socket.
The cigarette lighter
socket is dirty. This
results in a poor electri-
cal contact.
The fuse of the 12/24 V
plug has blown.
The vehicle fuse has
blown.
Autogoods "130"
Suggested remedy
The ignition must be switched on in most
vehicles to supply current to the cigarette
lighter.
Try using another plug socket.
If the plug of your cooler becomes very
warm in the cigarette lighter socket,
either the lighter socket must be cleaned
or the plug has not been assembled cor-
rectly.
Replace the fuse (10 A) in the 12/24 V
plug, see "Replacing the plug fuse
(12/24 V)" on page 28.
Replace the vehicle's 12/24 V socket fuse
(usually 15 A). Please refer to your vehi-
cle's operating manual.
CoolMatic FC40
EN

Publicité

Table des Matières
loading

Table des Matières