KitchenAid KFGC500JBK Instructions D'installation page 19

Replace Oven Bake Burner Cover
1. Align notches on the oven bake burner cover with shoulder
screws in the bottom of the oven.
A B
A. Cover notches (4)
B. Shoulder screws (4)
2. Lower cover, and slide to left or right to slide shoulder screws
into the narrow ends of the notches, then lock into place.
A
A. Bake burner cover
Convert Oven Broil Burner (30" [76.2 cm] and 36"
[91.4 cm] models and the right oven cavity on 48"
[121.9 cm] models)
1. Using a 1/4" (6.4 mm) nut driver, remove broil burner screw.
Set aside with side igniter positioned on the right.
A
B
C
A. Broil burner screw
B. Broil burner
C. Broil burner orifice hole
2. Pull the broil burner toward you until it slides out of the hole in
the oven back, and pull the electrode out of the bracket. The
broil burner will hang down in the back of the oven while you
change the orifice.
A
3. Apply masking tape to the end of a 1/4" (6.4 mm) nut driver to
help hold the gas orifice spud in the nut driver while changing
it. Insert nut driver into the gas opening, and press down onto
the gas orifice spud, then remove by turning the gas orifice
B
spud counterclockwise and lifting out. Set gas orifice spud
aside.
4. Propane gas orifice spuds are stamped with a letter and a
number. Install the Number 90 oven broil burner orifice spud.
5. Place Natural gas orifice in plastic parts bag for future use,
and keep with package containing literature.
6. Replace the broil burner in the hole in the oven back with the
broil burner assembly inside the broil burner electrode hole as
illustrated.
7. Reinstall the oven broil burner screw. See Step 1 for
illustration. The screw is aligned with the hole when
a click sounds.
A
B
A. Grasp electrode here.
B. Bracket
A B C
A. Oven back
B. Broil burner orifice
C. Broil burner orifice hole
A
A. Broil burner orifice hole
B. Broil burner electrode
C. Broil burner electrode hole
Broil burner hanging
in back of oven
B C
19