Kopp NFRAcontrol R 180 UP Mode D'emploi page 19

Connection of consumers
High starting currents severely reduce the useful life of
relays. For this, follow the technical instructions of the
lamp or light manufacturer. High inductive loads should
be switched by means of an additional relay or an addi-
tional contactor.
Internal microfuse - fuse replacement
Overloads or installation errors can lead to triggering of
the installed fuse. Switch off the circuit before replacing
the fuse and eliminate the cause of the error. Careful-
ly remove plastic front parts such as cover frame and
housing cap. Pull out 6 the fuse bracket and replace
the defective fuse with a new fuse. Ensure that only the
same type of fuse is used! Then, replace the fuse bracket
into the bracket. Assemble the device completely and
switch on the circuit again.
Fuse
6
Fuse bracket
Operation overview
8
8 7 

9
9
19
D
GB
NL
F
I
P