Associated Standards And Regulations; Accessories - IKA MF 10 Mode D'emploi

The mill IKA MF 10 is maintenace-free. It is subject only to the natural
wear and tear of components and their statistical failure rate.
When ordering spare parts, please give the manufacturing num-
ber shown on the type plate, the machine type and the name of
the spare part.
Please send in equipment for repair only after it has been cleaned and
is free from any materials which may constitute a health hazard. Use
only cleansing agents which have been approved by IKA to clean IKA devi-
ces. To remove use:
Dyes isopropyl alcohol
Construction materials water containing tenside / isopropyl alcohol
Cosmetics water containing tenside / isopropyl alcohol
Foodstuffs water containing tenside
Fuels water containing tenside
For materials which are not listed, please request information from IKA.
Wear the proper protective gloves during cleaning of the devices.
Electrical devices may not be placed in the cleansing agent for the purpo-
se of cleaning.
Before using another than the recommended method for cleaning or
decontamination, the user must ascertain with the manufacturer that this
method does not destroy the instrument.

Associated standards and regulations

Associated EU guidlines
EMC-guidline: 89/336/EWG
Low voltage-guidline: 73/023/EWG
Machine-guidline: 89/392/EWG
Construction in accordance with the following safety standards
EN 61 010-1
EN 292-1,
EN 60 204-1
UL 3101-1
24
EN 61 010-2-51
EN 292-2
EN 414
CAN/CSA C22,2 (1010-1)
Construction in accordance with the following EMV standards
EN 55 014-1
EN 50 081

Accessories

Sieve insert with hole sizes:
Ø 0,25mm Ø 1,50mm
Ø 0,50mm Ø 2,00mm
Ø 1,00mm Ø 3,00mm
MF 10.1 Cutting mill head
MF 10.2 Impact grinding head
Guarantee
You have purchased an original IKA laboratory machine which meets
the highest engineering and quality standards.
In accordance with IKA guarantee conditions, the guarantee period is
24 months. For claims under the guarantee please contact your local
dealer. You may also send the machine direct to our works, enclosing
the delivery invoice and giving reasons for the claim. You will be liable
for freight costs.
EN 50 082-1
MF10 0998 EU