GreenWorks GPW 1703 Manuel Du Propriétaire page 13

Table des Matières

Publicité

ASSEMBLY
CONNECTING HIGH PRESSURE HOSE TO TRIGGER HANDLE
• Align the pressure hose with the trigger handle and push up and into position.
• With hose pushed into position on the trigger handle, secure in place by turning the hose lock
clockwise until fully tightened.
NOTE: For easier installation of the hose to the unit or trigger, it is suggested to add pressure
washer or dish detergent to the rubber seal at each end of the hose. This will allow for easier
installation and a snug fit.
CONNECTING THE GARDEN HOSE
C A U T I O N
Always observe all local regulations when connecting hoses to the water main. Some areas have
restrictions against connecting directly to public drinking water supply to prevent the feedback of
chemicals into the drinking water supply. Direct connection through a receiver tank or back flow
preventer is usually permitted.
• Uncoil the garden hose.
NOTE: There must be a minimum of 10 feet of unrestricted garden hose between the water
intake and the garden hose faucet or shut off valve (such as a "Y" shut off connector).
• Run water through the hose (A) for 30 seconds to clean any debris from the hose.
• Inspect the screen in the water intake (B).
• If the screen is damaged, do not use the machine until the screen has been replaced.
• If the screen is dirty, clean it before connecting the garden hose to the machine.
• With the hose faucet turned completely off, attach the end of the garden hose to the water
intake. Tighten by hand only.
See Figure 6.
13
See Figure 5.
Fig. 5

Publicité

Table des Matières
loading

Table des Matières