Radio Operation; Setting The Clock - Bosch GML 24 V PROFESSIONAL Manuel D'utilisation

1 609 929 J80.book Seite 4 Montag, 27. März 2006 3:27 15
To increase the volume, turn the VOLUME control
knob 21 in clockwise direction. The selected vol-
ume is indicated for several seconds in the indica-
tor 31 (VOL 00 – 20).
To reduce the volume, turn the VOLUME control
knob 21 in anticlockwise direction.
To switch off the radio charger, press the power
button 6 again.

Setting the Clock

When plugging the mains plug into the outlet or
inserting a battery into the charge port, the radio
charger switches to the standby mode. The indi-
cated time on the display is "12:00". To adjust the
correct time, proceed as follows.
Press the TIME SET button 18. The time indica-
tion 29 flashes.
Press the HOUR button 19 as often as required
until the correct hour is indicated. You can also
press and hold the button until the correct hour
is indicated.
Press the MINUTE button 20 as often or as long
until the correct minute is indicated.
Press the TIME SET button 18 again. A "beep"
confirms the new setting.
Even when the device is switched off, the set
clock will continue to run, powered by the AAA
batteries.
Programming the Automatic Switch-off Func-
tion
The radio charger can be set to switch off automat-
ically after a preset period.
Press the TIME SET button 18 for three sec-
onds until the "_:_" symbol 29 time indication
flashes in the time indication.
Press the HOUR button for changing of hour in-
dication 19 to select one of the pre-adjusted
switch-off periods in steps of 30 minutes
("_2:00", "_1:30", "_1:00", "_:30", "OFF").
Press the TIME SET button 18 again at the de-
sired switch-off period. A "beep" confirms the
desired setting.
To indicate the remaining time until the radio
charger switches off, press the MINUTE button
for changing of minute indication 20.
If the radio charger is switched off via the POWER
switch 6 before the switch-off period has elapsed,
the automatic switch-off setting is deleted.
1 609 929 J80 • 06.03

Radio Operation

GML 24 V: Press the AUX/Radio FM/Radio AM
operating mode button 23 until FM 37 and AM 38
are indicated in the display.
GML 24 V-CD: Press
FM/Radio AM operating mode button 22 until
FM 37 and AM 38 are indicated in the display.
Connecting the Aerial
The radio charger is supplied with the mounted rod
aerial 52. Pivot the rod aerial in the direction with
the best reception.
Setting the Radio Station
Before setting a radio station, reduce the volume to
as low as possible.
Briefly turn the TUNE control knob 14 (GML 24
V-CD) or 24 (GML 24 V) in clockwise direction to
increase the frequency in steps of 0.05 MHz (FM
frequency band) or 10 kHz (AM frequency
band). The selected frequency is indicated in the
display 31.
Briefly turn the TUNE control knob 14 (GML 24
V-CD) or 24 (GML 24 V) in counterclockwise di-
rection to decrease the frequency in steps of
0.05 MHz (FM frequency band) or 10 kHz (AM
frequency band). The selected frequency is indi-
cated in the display 31.
Turn the TUNE control knob 14 (GML 24 V-CD)
or 24 (GML 24 V) and hold it in this position to
start the SEEK function. The tuner automatically
searches for the next radio station with good re-
ception.
When operating within the direct vicinity of radio
plants and radio equipment, radio reception can be
impaired.
Presetting Radio Stations
20 FM and 10 AM tuner presets are possible.
Before setting a radio station, reduce the volume to
as low as possible.
Select the desired FM or AM frequency band.
Select the radio station with the TUNE control
knob 14 (GML 24 V-CD) or 24 (GML 24 V).
Press the radio station MEMORY button 17. The
PRESET function indicator 42 and the indicator
for radio station preset 41 flash in the display.
Press the PRESET forwards 25 or back but-
ton 26 (GML 24 V) or the radio function PRE-
SET button 13 (GML 24 V-CD) to select the de-
sired preset number.
Press the radio station MEMORY button 17. A
"beep" confirms the adjustment.
English–4
the CD/AUX/Radio