Black & Decker PIUSB Mode D'emploi page 14

4. The Power/Fault LED Indicator (3) will light green, indi-
cating a proper connection. If the Power/Fault LED
Indicator lights red, a Fault condition exists. Refer to
the Troubleshooting Section of this Instruction Manual.
5. If the charger does not work, make sure the
ignition/accessory outlet is powering the accessory
outlet. Some vehicles require the ignition switch to be
turned on.
6. Lift the USB cover
C
(2) to allow access
to one or both of
the USB ports (1).
7. Plug the
USB-powered
device into the
USB Charging
Port and operate
normally.
Note: You can operate two USB devices simultaneously.
Notes: This charger does not support data
communication. It only provides
5 volts/500mA DC power to an external
USB-powered device.
Remember to disconnect the unit from
any power source when it is not in use.
14