Black & Decker PIUSB Mode D'emploi page 13

Note: Do not attach a USB extender to this unit to allow
additional items to be added.
To prevent damage, the unit will shut down if it is over-
loaded. To restart the unit you must remove it from the
power source, wait for a few seconds and then re-insert
the unit into the power source.
Operation of the USB Charging Ports
The tip of the plug is
A
positive (+) and the side
contact is negative (-).
1. Unfold the 12 Vdc accessory
plug (4) from the body of
the stick to one of the
preset positions (figure A).
2. Connect the unit to a
vehicle's accessory outlet or
other 12 volt DC power
B
source. Make sure there is
adequate space for proper
ventilation of the charger.
3. Rotate the unit slightly to
make sure there is good
contact.
13
4
3