Black & Decker PIUSB Mode D'emploi page 17

TROUBLESHOOTING
Power/Fault LED Indicator Lights Green
If the green LED indicator (3) is not lit:
• check that all the DC connections are connected correctly.
• check the tightness of the DC connection
NOTE: Make sure that your accessory outlet is "live". You
may need to turn the ignition key to the accessory position.
Power/Fault LED Indicator Lights Red
When the Power/Fault LED Indicator turns from green
(indicating the unit is powered) to red, a fault condition is
present and the unit will automatically shut down. See the
Protective Features Section of this Instruction Manual and
Common Power Output Problems in the following section.
Common Power Output Problems
Possible Causes Recommendations
Battery voltage Recharge battery or check
below 10.5 volts DC power supply.
Equipment being operated Reduce load to maximum
draws too much power 5 watts. Although this unit
has two outlets, some phones
and PDAS can take 5 watts
17