Publicité
16
ASSEMBLY
1) Locate a flat, dry area with access to electrical outlet or extension cord.
IMPORTANT: Because of the size and weight of the Catapult, careful thought must
be given to the setup area. Ideally, the Catapult should be carried into position while
inside it's protective storage bag. The best setup position will also make launching easy.
Therefore, locate the product near the water's edge.
NOTE: Dragging or sliding the product over ground either before or after inflation
can cause damage. It is best to attach Aquaglide items while they are deflated. Once
fully attached with Vario-Lock cinch straps, then inflate.
2) Once in the setup/ launch position, unfold the Catapult completely and locate the
Main Valve. The Main Valve is located on the lower half of the product, near the back
end on the right hand side.
3) Before inflation, attach swing via the 2 screw-gate carabiners to the two D-Rings.
Make sure to lock gate by screwing the locking sleeve into position.
WARNING: Check to make sure the gate on the carabiner is in the LOCKED position.
Not doing so can result in serious injury. North Sports, Inc. is not responsible for any
damage, injuries or losses due to improper locking of carabiners.
4) Using a high output pump, place the inflation hose with proper adaptor into the
Main Valve to inflate the Catapult. Inflate to 1.74 psi (0,119 bar). Check for proper air
pressure using a manometer. After inflation, replace Main Valve cover. Inflation times
can vary by inflator, but the main section should be firm and tight when completely
inflated. DO NOT OVER-FILL. Excessively high pressure can cause damage to the
product and may void the warranty. Carefully monitor air pressure in the product
especially during hot weather.
WARNING: Do not use an air compressor to inflate tube. Air compressors are
designed for high pressure inflation and can cause tube to burst if over-inflated.
WARNING: Do not use the Catapult without adequate air pressure.
5) Next locate the Catapult Platform Valve located on the floor of the Catapult.
Follow the instructions and warnings found in Step #3 to properly inflate the platform.
Inflate to 5.0 p.s.i. (0,345 bar). Check for proper air pressure using a manometer.
6) Follow the instructions and warnings found in Step #3 to properly inflate the Drop-
Stitch seat. Inflate to 1.74 p.s.i. (0,119 bar). Check for proper air pressure using a
manometer.
7) To launch the product, make sure to have at least 4 people evenly spaced around
the product to help carry it. NEVER DRAG THE PRODUCT! YOU MUST LIFT AND SET
THE PRODUCT ON THE WATER TO AVOID ANY ACCIDENTAL TEARING AND/OR
ABRASION.
How to connect your Aquaglide Products using the Vario-Lock cinch strap
Publicité
