Bluetooth Function - Pioneer XW-SX70 Mode D'emploi

Contents
Troubleshooting
„ Power
Cannot turn on the unit
• Make sure that the power cord is properly plugged into the wall outlet.
• Unplug the power cord from the outlet once, wait 5 seconds or more, then plug it in again.
The unit turns off unexpectedly
• The unit automatically enters standby mode when "Auto Standby" is activated.
• The protection circuit function may have operated due to an abnormal rise in temperature of the unit. In such a case, the power turns off
repeatedly even if the power is turned on each time. Secure sufficient ventilation space around the unit, wait for a while until the temperature of
the unit decreases. Then, turn the power on again.
WARNING: If smoke, smell or abnormal noise is produced by the unit, unplug the power cord from the outlet immediately, and contact the dealer or
our company's support.
„ Audio
No sound from a connected player
• Change the input selector on this unit to the position of the terminal to which the player is connected.
„ BLUETOOTH function
• Unplug and plug the power cord of the unit, or turn off and on the BLUETOOTH-enabled device. Restart of the BLUETOOTH-enabled device
may be effective.
• BLUETOOTH-enabled devices must support the A2DP profile.
• Because a radio wave interference will occur, this unit may not be used near devices such as a microwave oven or cordless phone which use
the radio wave in the 2.4 GHz range.
• A metallic object near the unit can affect on the radio wave, and BLUETOOTH connection may not be possible.
Check the following if the problem persists after you have confirmed the above.
Cannot connect with this unit
• Check if the BLUETOOTH function of the BLUETOOTH-enabled device is enabled.
Preparations
≫ ≫
35
Playback Voice Functions
≫
Top Panel≫ Front Panel≫ Rear Panel≫
Setup
≫ ≫
( p8)
( p30)
( p10)