VWR INCU-Line ILS4 Manuel D'instructions page 12

7.5 Shaker Control System
• Time signal light is on. By rotating the Control Knob right (+) or left (-) the set
time can be selected from 30 sec to 99 min 50 sec :
• If you want to set the timer to hold – turn the knob left or right until HLd is
displayed. You can reach the HLd function by setting to under 0.30 or above
99.5
• Push down on the Control Knob to switch modes between time set mode and
RPM set mode.
• RPM signal light is on. By rotating the Control Knob right (+) or left (-) the desired
RPM can be selected :
• Press START/STOP button to start operation
• RUN and TIME signal lights on. Shaker runs and counts down time from set
value.
• NOTE: If there is a power outage during operation, shaking incubator will restart
automatically, as soon as the electricity returns. Display will be flashing (warning
you that the power was cut). You can turn the flashing off, by pressing the
Control Knob.
• If you want change the RPM during shaking, push the Control Knob to put the
shaker into RPM set mode (RPM signal light will be on). Rotate the Control Knob
right (+) or left (-) to set the desired value. In the meantime RPM signal light will
flash. When you stop rotating the Control Knob the signal light for RPM will stop
flashing after 2 sec.
• When the run time has elapsed or when you press the START/STOP button, the
display will show "End" and the RUN light will flash. When shaker completely
stops the set speed and time will return to the last programmed values.
99.5 ⇒ 99 min 50 sec
9.59 ⇒ 9 min 59 sec
0.30 ⇒ 30 sec
34 ⇒ 340 Rpm
120 ⇒ 1200 Rpm