Intended Use; Basic Safety Instructions - Burkert 2030 Mode D'emploi

3

INTENDED USE

Non-authorized use of the devices may be dangerous to
people, nearby equipment and the environment.
▶ The diaphragm valves of Types 2030, 2031, 2032, 2033 and
2037 are designed for the control of contaminated, ultra-pure or
sterile media, as well as for abrasive or aggressive media (also
with higher viscosity).
▶ The device is designed for the controlled flow of liquid and gas-
eous media.
▶ The devices may be used only for media which do not attack
the body and seal materials (see type label). Information on the
resistance of materials to the media is available on the Internet at:
www.burkert.com → resistApp.
▶ In potentially explosive atmospheres, only use devices that are
approved for this purpose. These devices are identified by a sepa-
rate Ex type label. Before use, note the information on the separate
Ex type label and the Ex additional instructions or the separate Ex
operating instructions.
▶ During use observe the authorized data, the operating condi-
tions and conditions of use specified in the contract documents,
operating instructions and on the type label.
▶ Protect device from damaging environmental influences (e.g.
radiation, humidity, steam, etc.). If anything is unclear, consult the
relevant sales office.
▶ The device may be used only in conjunction with third-party
devices and components recommended and authorized by
Bürkert.
▶ Correct transportation, correct storage and installation and care-
ful use and maintenance are essential for reliable and faultless
operation.
4
english
Type 2030, 2031, 2032,
Intended Use
▶ Use the device only as intended.
4

BASIC SAFETY INSTRUCTIONS

These safety instructions do not consider any contingencies or inci-
dents which occur during installation, operation and maintenance.
The operator is responsible for observing the location-specific safety
regulations, also with reference to the personnel.
Risk of injury from high pressure and discharge of medium.
▶ Before working on the device or system, switch off the pressure.
Vent or drain lines.
Danger of bursting from overpressure.
▶ Observe the specifications on the type label for maximal control
and medium pressure.
▶ Observe permitted medium temperature.
Risk of injury from electric shock (when electrical component
installed).
▶ Before reaching into the device or the equipment, switch off the
power supply and secure to prevent reactivation!
▶ Observe applicable accident prevention and safety regulations
for electrical equipment!
Risk of injury from moving parts in the device!
▶ Do not reach into openings.
2033, 2037