Plan The Installation - GE UVC9300 Mode D'emploi

TOOLS AND MATERIALS REQUIRED (NOT SUPPLIED)
Pencil and tape measure
Level
Level 2
Tin snips
Wire cutter/
stripper
Wire Cutter/Stripper
PARTS PROVIDED
Locate the parts packed with the hood.
NOTE: The hardware bag may contain extra pieces
to accommodate a variety of installation methods
for various models.
Hardware Bag
A
761Dia65
Phillips Head Philips Head
Wood Screws Machine Screw
3/16" x 1-1/2" 1/8" X 3/8"
(QTY: 4) (QTY: 16)
D
Phillips Head
761Dia68
Wood Screws
1/8" X 3/8" (QTY: 4)
29-6325
Installation Preparation
Aluminized
duct tape
Duct Tape
Step ladder
Ladder
Flashlight
UL listed wire nuts
Wire Nuts
Hood
B
Damper
Assembly
L
Phillips Head
Wood Screws
3/16" x 1"
(QTY: 8)
Needle-nose pliers
Safety glasses
Safety Glasses
Phillips and flat-blade
screwdrivers
Strain Relief I

PLAN THE INSTALLATION

CAUTION
properly exhaust air, be sure to duct the air
outside – Do not vent exhaust air into spaces
within walls or ceilings or into attics, crawl
spaces, or garages.
WARNING
PERSONAL INJURY HAZARD
It is recommended that 2 people are used to
install the range hood. Failure to properly
lift rangehood could result in damage to the
product or personal injury.
NOTE: This rangehood can be installed as either
ducted or recirculation. In a ducted application,
this rangehood can be vented through the wall
or ceiling. When installed for recirculation, the
rangehood vents back into the room.
REMOVE THE PACKAGING
CAUTION
sharp edges.
■ Remove the hardware bag, literature package
and other boxed parts.
■ Remove and properly discard the protective
plastic wrapping and other packaging materials.
Electric drill and
appropriate bits
762Dia5
8" ducting and
caps as needed
Strain relief for
Gloves
junction box
To reduce risk of fire and to
Wear gloves to protect against
1" = 2.5 cm
11