Accessories - Scheppach CS55 Mode D'emploi

Accessories

RAIL
m Maintenance
If specialist personnel must be brought in for ex-
traordinary ser vice or repairs during the warranty
period and thereafter, please contact a service pro-
vider recommended by us or con tact the manufac-
turer directly.
• Overhauls, maintenance work, cleaning, as well as
the eli mi nation of any malfunctions must only be un-
dertaken af ter turning off the motor.
• All protective and safety equipment must be rein-
stalled immediately upon completion of any repair or
maintenance work.
Problem
The motor does not run. Faulty motor, power supply cable or plug.
The motor starts slowly
and does not reach run-
ning speed.
Excessive motor noise.
The motor does not
reach full power.
Motor overheats easily
Decrease in cutting
power when sawing
The saw cut is rough or
wavy
The work piece rips or
splinters
20
1400 MM
Trouble shooting
Possible Cause
Burned out fuses.
Low power supply voltage. Damaged wind-
ings. Burned out capacitor.
Damaged windings. Faulty motor.
Overloaded circuit due to lighting, utilities or
other motors.
Overload of the motor; inadequate cooling of
the motor
The saw blade is too small (sharpened too
often)
The saw blade is dull; the tooth shape is not
suited to the thickness of the material
The cutting pressure is excessive or the saw
blade is not suited to the application
REGULAR MAINTENANCE
The regular maintenance decribed above and in the
para graph below can be carried out by unskilled person-
nel.
• Do not oil the plunge cut saw, cause cutting must be
carried out in dry conditions; all rotating parts are self-
lubricating.
• During maintenance, wear protective gear if possible
(accident-prevention goggles and gloves).
• Remove cuttings when necessary both from the cut-
ting area, work surfaces and support bases.
Use of an aspirator or brush is recommended.
ATTENTION: Do not use compressed air jets!
• Regularly check blade conditions: if difficulties should
arise during cutting, have it sharpened by skilled per-
sonnel or replace it if necessary.
ASSISTENCE
When in need of skilled personnel for special main-
tenance, or for repairs, both during and following the
guarantee pe riod, always apply to authorized centres for
assistance or directly to the manufacturer if there is no
authorized centre in your area.
DISPOSAL OF THE MACHINE.
Once its operating activity is finished, the disposal of the
machine must take place through a normal collection
and disposal Center for industrial waste.
Help
Have the machine checked by skilled person-
nel. Do not try to repair the machine your-
selves as it may be dangerous. Check the
fuses and replace them if necessary.
Ask for the Electricity Board to check the
voltage available. Have the machine motor
checked by skilled personnel. Have the ca-
pacitor replaced by skilled personnel.
Have the motor checked by skilled personnel.
Do not use other utilities or motors on the cir-
cuit to which the plunge cut saw is connected.
Prevent overloading the motor when cutting;
remove dust from the motor to ensure an
optimum cooling of the motor
Re-adjust the end stop of the saw unit
Re-sharpen the saw blade or use an appropri-
ate saw blade
Use the correct saw blade