Delayed Cooking; Independent Timer; Elapsed Time - De Dietrich DTI1008X Guide D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
2 / USING YOUR APPLIANCE
E

•Delayed cooking

This function allows you to delay your cooking
(available only for the S
Program delayed cooking in 6 steps:
1 - Select the cooking zone dedicated to this
function.
2 - Press simultaneously on touchpads I "+"
and "–" to adjust the current time of your
hob. When the numbers flash, you can
adjust the hour with the touchpad I, then
wait a few moments. If the hour displayed
is correct, wait a few moments. The display
will stop flashing and a beep will confirm
the setting.
3 - Set the end of cooking time by pressing on
touchpad I. Wait a few moments. A beep
will confirm your setting.
4 - Set the duration of cooking time by press-
ing on touchpad I. Wait a few moments. A
beep will confirm your setting.
5 - Set the power of your cooking by pressing
on touchpad E, 4 is displayed by default
(maximum 6). Wait a few moments. A beep
will confirm your setting and SC is dis-
played on your hob.
6 - After a few moments, SC goes out and a
flashing point appears to indicate that
delayed cooking has been engaged.

•Independent timer

This function allows you to time an event, with-
out cooking.
- Select a cooking zone you are not using.
- Set the time with touchpad I. A "t" flashes in
the display.
- At the end of your adjustment "t" becomes
becomes fixed and the count begins.
Note:
You can stop a count in progress by keeping
your finger on the touchpad of the selection
on the display.
A
C
B
D
zone).
TART CONTROL
H
F
G

•Elapsed time

This function displays the time elapsed since
the last power setting adjustment on a cho-
sen zone.
To use this function, press the J J button. The
elapsed time flashes on the timer display of
the selected zone.
If you want cooking to end in a specific peri-
od, press button J J then, in 5 seconds, press
"+" on the timer to increase the cooking time
that you wish to set. The time display
becomes steady for 3 seconds then the
remaining time is displayed. There is a beep to
confirm your choice.
This function exists with or without the timer
function.
Note: If a time is displayed on the timer, this
time cannot be changed during the 5 seconds
after pressing the J J button. Once these 5 sec-
onds have elapsed, you may change your
cooking time.
9
EN
I
K
J

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dti1008jMw505s

Table des Matières