Beko HCA62620B Mode D'emploi page 10

4 Installation
2. Into the openings, insert the screw plugs. In
two openings marked with A screw also the
screws (leaving 7 mm of screw length outside
the screw plug, Fig.5).
2 x O5 x 45mm
4 x O8 x 40mm
Fig.5 Screw plugs assembly
3. Screw the chimney body fastening element,
hang the hood on two untightened screws
(Fig. 6).
Fig.6 Hood hanging
10 / EN
2 x O8 x 40mm
A
4. Open the hood cover and remove the fat filter
(Fig.7).
2
Fig.7 Aluminium fat filter removing
5. Place the level on the hood body. Rotating
the element marked with A, adjust the hood
level according the level's indications, and
then tighten two screws previously screwed
partially and screw in two remaining screws
(Fig. 8).
Fig.8 Range hood positioning
1
A
2 x O5 x 45mm
Hood / User Manual