Electrical Connections - Beko HCA62620B Mode D'emploi

4 Installation
Place the chimney body on the hood body.
Then, draw delicately the hood part signed
with B upwards, until it becomes possible to
screw it to the fastening element previously
attached to the wall (Fig. 9).
Be especialy attentive while sliding the
chimney body
Fig.9 Chimney body assembly
This assembly operation shall be
C
performed very carefully, in order
to avoid the scratching of chimney
body and hood itself.

4.2 Electrical connections

The network voltage shall correspond to the
voltage indicated at the plate placed inside the
hood. If the hood is equipped with a plug, insert
it into the socket complying with the applicable
requirements, and located in the easily accessi-
ble place. If the hood is not equipped with a plug,
the hood installations shall be performed by a
person having the required authorizations (such
as electrician).
Hood / User Manual
2 x O3,9x9,5
B
A
A
B
11 / EN