Hot Water Dispensing; Steam Dispensing - LaCimbali M100 Manuel D'utilisation Et Installation

Scalding hazard! Use the appropriate insulating devices to move the water and steam wands.
After positioning a container under the dispensing nozzle, the product can be dispensed in two ways:
1
1 and 2.
Scalding hazard! Use the appropriate insulating devices to move the water and steam wands.
Dispensing with the Turbosteam selector (13)
1
Use the selector (13) knob to select
the type of frothed milk from the four
available settings (TS1 ÷ TS4).
Steam dispensing with knob control (20)
1
20
9
02_M100_multi_ridotto.indd 12

15. Hot water dispensing

2
In CONTINUOUS mode, using the
START key.

16. Steam dispensing

2
13
The type of frothing is displayed on the
touch screen.
Insert the steam dispensing
wand (9) in a suitable container.
Turn the steam knob (20)
clockwise to start dispensing
and counter-clockwise to stop it.
12 EN
The bar below the water buttons
indicates the temperature of the water:
longer bar = higher temperature.
3
Press the selector (13) to start
dispensing. Once the set temperature
is reached, the steam will stop
automatically.
Note: At the conclusion of each steam dispensing
phase, clean the inside of the steam nozzle as
follows:
Turn the nozzle towards the cup tray and carefully
activate steam dispensing at least once.
13
11/03/2014 10:27:58