Ordering Replacement Parts - EINHELL BK 315/400 Mode D'emploi

Anleitung BK 315-400 SPK 1
all the way through.
Switch off the saw again. Important: Do not
remove the offcut until the blade has stopped
rotating!
The standard end stop (52) can be used for
repeat cuts. To do this, flip down the end stop
and set it to the desired dimension by means of
the thumb screw (63).
10.0. Maintenance
Important! Pull out the power plug first.
Remove dust and dirt regularly from the
machine. Cleaning is best carried out with a fine
brush or a cloth.
Never use caustic agents to clean plastic parts.

11.0. Ordering replacement parts

Please provide the following information on all orders
for replacement parts:
Model/type of device
Article number of the device
ID number of device
Number of the required replacement part
05.10.2004 10:22 Uhr Seite 25
GB
25