4�2 Cleaning Internal Space; 4�3 Cleaning Grinding Table; 4�4 Cleaning Rinse Tube; 4�5 Cleaning Water Inlet Sieve - Renfert MT3 Mode D'emploi

4.2 Cleaning internal space
• Turn off appliance and wait, until the trimmer disk comes to an complete standstill�
• Open door latches (Fig� 9), remove door and set aside�
• Clean door with a brush or cleaning cloth under running water�
• Wipe the internal space with a brush or cleaning cloth�
4.3 Cleaning grinding table
• Turn off appliance and wait, until the trimmer disk comes to an complete standstill�
• Pull grinding table (5) at leading edge upward from ball
• Clean grinding table with a brush under running water�
4.4 Cleaning rinse tube
• Turn off appliance and wait, until the trimmer disk comes to an complete standstill�
EN
• Close water supply shutoff tap�
• Pull grinding table at leading edge upward from ball
• Open door latches (Fig� 9), remove door and set aside�
• Turn rinse tube (18) backwards at curved side and take out (Fig� 11)�
• Allow the rinse tube to soak in decalcifying agent overnight�
• Replace rinse tube by pressing rinse tube into both clamps (Fig�
4.5 Cleaning water inlet sieve
• Pull mains plug�
• Close water supply shutoff tap�
• Disconnect water hose (9, Fig� 3) from water connection (12, Fig� 3)�
• Use pliers to pull out sieve and clean it�
• Put sieve back in place�
4.6 Flange Replacement
• Turn off appliance and wait, until the trimmer disk comes to an complete standstill�
• Pull mains plug�
• Open door latches (Fig� 9), remove door and set aside�
• Remove the disc (chap� 3�4)�
• Screw pull-off tool (11) into flange (23) until flange comes off.
The flange may not be removed by hand. Always use the pull-off tool to remove the
flange!
• Remove the flange.
• Unscrew the pull-off tool�
• If necessary clean space behind flange.
• If necessary, clean the hub�
• Replace new flange >>> Note the engagement groove (Fig. 15)�
• Replace the flange by hand on the shaft.
• Reinstall the grinding disc (chap� 3�4)�
• Put door back in postion and close the door latches�
• Plug in at the mains�
5.

Spare Parts

You can find components subject to wear and the spare parts on the spare part list in the internet at
www.renfert.com/p918
The components excluded from the warranty (such as consumables or parts subject to wear and tear) are marked on
the spare part list�
Serial number and date of manufacturing are shown on the type plate of the unit�
EN
head�
head�
12)�
- 6 -
18
Fig� 11
Fig� 12
Fig� 13
23
11
Fig� 14
Fig� 15