Electronic Adjustment; Filling The Rinse Aid Dispenser - Electrolux FAVORIT 78025 VI Mode D'emploi

Electronic adjustment

1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to 'SET-
TING AND STARTING A PRO-
GRAMME'.
2. Press and hold buttons (4) and (5) at
the same time until the indicators of
buttons (3), (4) and (5) flash.
3. Press button (3).
• The indicators of buttons (4) and (5)
go off.
FILLING THE SALT CONTAINER

FILLING THE RINSE AID DISPENSER

A B
A
-
+
C
D
• The indicator of button (3) contin-
ues to flash.
• The acoustic signals operate. Exam-
ple: five intermittent acoustic signals
= level 5.
• The display shows the setting of the
water softener. Example:
el 5.
4. Press button (3) again and again to
change the setting.
5. Deactivate the appliance to confirm.
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt contain-
er (only for the first time).
3.
Fill the salt container with dishwasher
salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out from
the salt container when you fill it.
Risk of corrosion. To prevent it, af-
ter you fill the salt container, start
a programme.
1. Press the release button (D) to open
the lid (C).
2. Fill the rinse aid dispenser (A), no
more than the mark 'max'.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
You can turn the selector of the
released quantity (B) between po-
sition 1 (lowest quantity) and posi-
tion 4 (highest quantity).
ENGLISH
31
= lev-