Manual Adjustment; Electronic Adjustment - Electrolux ESL63010 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

www.electrolux.com
8

Manual adjustment

Electronic adjustment

1. Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
3. Press and hold the programme button
until the programme indicator (A)
flashes and the programme indicator
(B) comes on.
4. Wait until the programme indicator (B)
goes off and the end indicator starts to
flash (the programme indicator (A)
continues to flash).
6.2 Filling the salt container
Turn the water hardness dial to the posi-
tion 1 or 2.
5. Press the programme button.
• The end indicator flashes intermit-
tently. The number of flashes shows
the level of the water softener. Ex-
ample: 5 flashes + pause + 5 flash-
es = level 5.
6. To adjust the level of the water soften-
er, press the programme button. Each
time you press the programme button
you go to the next level.
7. Deactivate the appliance to confirm.
1.
Turn the cap counterclockwise and
open the salt container.
2.
Put 1 litre of water in the salt contain-
er (only for the first time).
3.
Fill the salt container with dishwasher
salt.
4.
Remove the salt around the opening
of the salt container.
5.
Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out from
the salt container when you fill it.
Risk of corrosion. To prevent it,
after you fill the salt container,
start a programme.

Publicité

Table des Matières
loading

Table des Matières