Setting Mode - Electrolux ESL63010 Notice D'utilisation

10 www.electrolux.com
7.1 Using the detergent
D
A
3
7.2 Using the combi detergent
tablets
When you use tablets, that contain salt
and rinse aid, do not fill the salt container
and the rinse aid dispenser. The rinse aid
indicator always comes on if the rinse aid
dispenser is empty.
1. Adjust the water softener to the lowest
level.
2. Set the rinse aid dispenser to the low-
est position.
If you stop to use the combi
detergent tablets, before you
start to use separately
detergent, rinse aid and
dishwasher salt, do these steps:
1. Press the on/off button to activate the
appliance.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
A B
30
20
C
B D
0
2 0
+
1.
Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
4. If you use detergent tablets, put the
tablet in the compartment (A).
5.
Close the lid. Make sure that the re-
lease button locks into position.
A
-
C
4. Start the shortest programme with a
5. Adjust the water softener to the water
6. Adjust the released quantity of rinse
7.3 Setting and starting a
programme

Setting mode

The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when,
after the activation:
• All the programme indicators are off.
• The end indicator flashes.
If the control panel shows other condi-
tions, press and hold the programme but-
ton until the appliance is in setting mode.
rinsing phase, without detergent and
without dishes.
hardness in your area.
aid.