Electronic Adjustment - Electrolux ESF6210LOK Notice D'utilisation

Electronic adjustment

1. Make sure that the programme marker
on the knob is aligned with the on/off
indicator.
2. Press and hold Start. At the same
time turn the knob clockwise until the
programme marker is aligned with the
first programme on the control panel.
3. Release Start when the Start and the
on/off indicator start to flash. The end
indicator starts to flash. The intermit-
tent flashing of the end indicator refers
to the current set level.
5.2 Filling the salt container
• E.g. 5 flashes + pause + 5 flashes =
level 5.
4. Press Start again and again to
change the setting. Each time you
press Start the level number increa-
ses.
5. To confirm the setting and deactivate
the appliance, turn the knob until the
programme marker is aligned with the
on/off indicator.
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt contain-
er (only for the first time).
3. Fill the salt container with dishwasher
salt.
4. Remove the salt around the opening
of the salt container.
5.
Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out from
the salt container when you fill it.
Risk of corrosion. To prevent it,
after you fill the salt container,
start a programme.
ENGLISH 23