Installation; To Guard Against Electromagnetic Interference; Before Installing - Pioneer AVIC-HD3 Mode D'emploi

Installation

• Install this navigation system between the driver's seat and front passenger
seat so that it will not be hit by the driver or passenger if the vehicle stops
quickly.
• Never install this navigation system in front of or next to the place in the
dash, door, or pillar from which one of your vehicle's airbags would deploy.
Please refer to your vehicle's Owner's Manual for reference to the deploy-
ment area of the frontal airbags.
• Do not install this navigation system in a place where it will impair the per-
formance of any of the vehicle's operating systems, including airbags and
headrests.

To guard against electromagnetic interference

• In order to prevent interference, set the following items as far as possible from this navi-
gation system, other cables or leads:
- TV aerial and aerial lead
- FM, MW/LW aerial and its lead
- GPS aerial and its lead
In addition you should lay or route each aerial lead as far as possible from other aerial
leads.
Do not bind them together, lay or route them together, or cross them.
Such electromagnetic noise will increase the potential for errors in the location display.

Before installing

• Consult with your nearest dealer if installation requires the drilling of holes or other mod-
ifications of the vehicle.
• Before making a final installation of this navigation system, temporarily connect the
wiring to confirm that the connections are correct and the system works properly.
• Do not install this navigation system in a position where the opening of the LCD panel is
obstructed by any obstacles, such as the shift lever. Before installing this navigation sys-
tem, be sure to leave sufficient space so that the LCD panel does not obstruct the shift
lever when it is fully opened. This may cause interference with the shift lever, or a mal-
function of the mechanism of this navigation system.
19