Before Installing This Navigation Unit; Installation With The Holder And Side Bracket - Pioneer AVIC-HD3 Mode D'emploi

Before installing this navigation unit

• Remove the holder.
Loosen the screws (3
remove the holder.
Holder
Screw (3 × 6 mm)

Installation with the holder and side bracket

1. Install the holder into the dashboard.
After inserting the holder into the dash-
board, select and bend the tabs appro-
priate to the thickness of the dashboard
material. (Install this navigation unit as
firmly as possible using the top and
bottom tabs. To secure this navigation
unit, bend the tabs 90 degrees.)
Dashboard
Holder
×
6 mm) to
2. Install this navigation unit and
fasten the screws.
Dashboard
Screw (3 × 6 mm)
Be sure to attach the rubber bush to the
long end of double-ended screw.
3. Attach the trim ring.
Trim ring
Rubber bush* 1
Double-ended
screw
22