Setting Up Analogue Tv Channels Manually; Reducing Video Noise; Setting Channel Lock - Pioneer KURO KRP-600A Mode D'emploi

Setting up
To replace registered channels with new channels, select "Replace
Existing Channels" (see page 49).
"Reset" restores all satellite settings to factory default values.
19 Press HOME MENU to exit the menu.
Setting up analogue TV channels
manually
Use the Manual Adjust function to set up analogue TV channels
manually.
1 Press HOME MENU.
2 Select "Setup" (/ then ENTER).
3 Select "System Setup" (/ then ENTER).
4 Select "Analogue TV Setup" (/ then ENTER).
The password entry screen appears. Enter your four-digit password
using buttons 0 to 9. For the password, see Using a password on
page 64.
5 Select "Manual Adjust" (/ then ENTER).
Manual Adjust
Label
Sort
6 Select "Programme Entry" (/).
7 Select a programme number (/).
You can select 1 through 99.
8 Select "Search" (/).
9 Enter a frequency using buttons 0 to 9, then ENTER.
You can also press / to enter a frequency.
10 Select "System" (/).
11 Select a sound system (/).
You can select from among "B/G", "D/K", "I", "L", and " L' ".
12 Select "Colour System" (/).
13 Select a colour system (/).
You can select from among "Auto", "PAL", "SECAM", and "4.43NTSC".
14 Select "Store" (/).
15 Select "Yes" or "No" (/).
Item Description
You can select the channel using P+/P–
Yes
No You cannot select the channel using P+/P–
16 Press HOME MENU to exit the menu.
Alternatively, to set up for another channel, repeat steps 7 to 15.
Note
• The above procedure transfers and sets the selected channel
information to the connected recording equipment such as a
VCR or DVD/HDD recorder (DVR).
• Manual Adjust also allows you to make selections for "Tuner
NR", "Channel Lock", and "Decoder". See Reducing video noise,
Setting Channel Lock, and Selecting a decoder input terminal.

Reducing video noise

For the individual channels, you can specify whether the flat screen
TV should reduce video noise depending on the levels of
broadcasting signals.
1 Repeat steps 1 to 5 provided for
channels manually .
2 Select "Tuner NR" (/).
3 Select "On" (/).
4 Press HOME MENU to exit the menu.
Note
• This function may not achieve a satisfactory result, depending on
the conditions of broadcasting signals.
• When using a decoder with a decoder terminal selected, this
function may fail to achieve a good result.
• The factory default is "On".

Setting Channel Lock

Channel Lock inhibits selected TV channels from being tuned and
watched.
1 Repeat steps 1 to 7 provided for
channels manually .
After selecting a channel (using Programme Entry), perform the
following steps:
2 Select "Channel Lock" (/).
3 Select "Block" (/).
The selection is switched between "View" (factory default) and
"Block".
4 Press HOME MENU to exit the menu.
Setting up analogue TV
Setting up analogue TV
08
35
En