Using I/O Link.a; Selecting The Scart Terminal For Use With I/O Link.a - Pioneer KURO KRP-600A Mode D'emploi

12 Using with other equipment

Using i/o link.A

The flat screen TV incorporates three typical i/o link.A functions for
smooth connections between the Media Receiver and other
audiovisual equipment.
One Touch Play
While the flat screen TV is in standby mode, it automatically turns
on and plays back images from the audiovisual source (e.g. VCR,
DVD).
WYSIWYR (What You See Is What You Record)
When the remote control unit of the connected VCR has the
WYSIWYR button, you can automatically start recording by pressing
the WYSIWYR button.
Preset Download
Automatically transfers channel preset information from the tuner
on the flat screen TV to the one on the connected audiovisual
equipment (e.g. VCR) via the INPUT 2 or INPUT 3 terminal.
Selecting the SCART terminal for use with
i/o link.A
The INPUT 2 and INPUT 3 terminals on the Media Receiver are
available for use with i/o link.A. Select which is to be used.
1 Press HOME MENU.
2 Select "Setup" (/ then ENTER).
3 Select "System Setup" (/ then ENTER).
4 Select "i/o link.A" (/ then ENTER).
5 Select a setting (/ then ENTER).
Item Description
INPUT 2 (default) INPUT 2 is available for i/o link.A
INPUT 3 INPUT 3 is available for i/o link.A
6 Press HOME MENU to exit the menu.
Note
• The i/o link.A functions work only when the audiovisual
equipment is connected to the INPUT 2 or INPUT 3 terminal on
the Media Receiver with i/o link.A via a fully wired 21-pin SCART.
• Refer to operation manuals of each external equipment for the
details.
• If a SCART cable has been connected to the INPUT 3 terminal
with the i/o link.A activated, input signals (other than
Component) are automatically identified and displayed. If the i/o
link.A has been deactivated, Video is always selected for signals
other than RGB because the system cannot identify among RGB,
Y/C (S-Video), and CVBS (Video) signals; for example, receiving
Y/C (S-Video) signals results in monochrome display.
72
En