Compulsary Inspections And Checks; Storage And Maintenance - Tractel AutoHook Mode D'emploi

COMPULSARY INSPECTIONS AND CHECKS

Maintenance inspections and operations must be performed by qualified and entitled persons.
 Check on start up (or starting back up): in compliance with the national regulations.
Compulsory periodical check in compliance with the national regulations. Recommended

at least every 12 months by TRACTEL SOLUTIONS SAS.
 A thorough examination paying particular attention to any alteration of parts due to an
impact, corrosion, cracking or deformation must be conducted a minimum of twice a year,
every month in the case of heavy-duty use in an aggressive atmosphere.
 TRACTEL SOLUTIONS is at your disposal in order to conduct any regulatory check.
 Regularly check the equipment is in perfect working order (before every use), in particular
the hooking ring joint and the screws.
 Perform visual inspection before every use.
Any part with a defect must be replaced by a TRACTEL SOLUTIONS part.

 Any deformed equipment must be immediately withdrawn from use.
Maintenance inspections and operations must be performed by qualified and entitled persons.
 Regularly check the equipment is in perfect working order (before every use), in particular
the semi-automatic system and the pivoting pads.
Perform visual inspection before every use.

 Any part with a defect must be replaced by a TRACTEL SOLUTIONS part.
 The hook has to be stored in an safe place, at ambient temperature
During the storage, the hook has to be in a stable position without risks of tipping over. On

request, Tractel Solutions supplies appropriate storage supports
 Any overloaded equipment must be immediately withdrawn from use.
M 6124 M
rev 10 – 06/2021
GB

STORAGE AND MAINTENANCE

Page 15/42
www.tractel.com