Step 12 Connect Water Supply; Step 13 Connect Drain Line - GE ZBD1850 Série Mode D'emploi

Installation Instructions

STEP 12 CONNECT WATER SUPPLY

Connect water supply line to 90° elbow.
• Slide compression nut,
then ferrule over end of
water line.
• Insert water line into 90°
elbow.
• Slide ferrule against
elbow and secure with
compression nut.
Figure EE
IMPORTANT
– Check to be sure that door spring does
not rub or contact the fill hose or water supply line. Test by
opening and closing the door. Re-route the lines if a rubbing
noise or interference occurs.

STEP 13 CONNECT DRAIN LINE

FOLLOW ALL LOCAL CODES AND ORDINANCES.
The molded end of the drain hose will fit 5/8" through 1"
diameter inlet ports on the air gap, waste tee or disposer.
• Determine size of inlet port
the inlet port.
Cutting Lines
1" 3/4"
Figure FF IMPORTANT: Do not cut corrugated
portion of hose
• If a longer drain hose is required, add up to 42" of length for
a total of 10' to the factory installed hose. Use 5/8" or 7/8"
inside diameter hose and a coupler to
connect the two
hose ends.
Secure the
connection with
hose clamps.
Figure GG
• Secure the drain hose to the air gap, waste tee or disposer
with clamps.
Note: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10' FOR
PROPER DRAIN OPERATION.
12
Compression Nut
Ferrule
Hot Water
90° Elbow
Supply Line
5/8"
DRAIN LINE INSTALLATION
• Connect drain line to air gap, waste tee or disposer using
either previously determined method.
Method 1 – Air gap with waste tee or disposer
Insert the drain hose to air gap as shown.
Waste Tee Installation
Figure HH
Method 2 – Drain Hose Routing
Route the drain hose of the dishwasher to a minimum height of 32" from
g g pp
32"
Min.
18"
Min.
Waste Tee Installation
Figure II
IMPORTANT
– Either one of the above methods
must be used or dishwasher will not operate properly.
IMPORTANT
– When connecting
drain line to disposer, check to be sure
that drain plug has been removed.
DISHWASHER WILL NOT DRAIN IF
PLUG IS LEFT IN PLACE.
Tip: Avoid unnecessary service call charges. Always be sure
disposer drain plug has been removed before attaching
dishwasher drain hose to the disposer.
Disposer Installation
g g pp
32"
Min.
18"
Min.
Disposer Installation