Oki PT390 Manuel D'utilisation page 91

(4) OTHER setup items
No. Item
1 ACK PULSE
WIDTH
2 USB
3 SERIAL NUMBER
4 ERROR
5 PROCESS ID
6 PNE DETECT
7 FONT B
8 BATCH (COM IF)
9 BATCH
(OTHER IF)
10 CUTTER MODE
Explanation
- Specifies the ACK pulse width.
- Specifies the use of the USB connection.
V-COM : Virtual COM class.
PRINTER: Printer class.
- Specifies the type of Serial Number
notification in a USB connection.
Generally, specify "DISABLE."
- Specifies the mode for the power-on time and
the error recovery time.
AUTO RECOVERY:
Windows drivers are used.
RECOVERY BY CMND:
OPOS drivers are used.
- Specifies a process ID.
NORMAL:
Responds with the process ID at the end of
printing.
HI-SPEED:
Responds with the process ID at the end of
data reception.
- Specifies whether to report the
Paper-near-end condition.
- Specifies Font B.
MODE 1: Font in the standard specifications
MODE 2: Other font
- ENABLE:
Received data is printed in a batch.
- DISABLE:
Received data is printed serially.
* This item is valid only with the serial
interface.
- ENABLE:
Received data is printed in a batch.
- DISABLE:
Received data is printed serially.
* This item is valid only with the USB, parallel
or LAN interface.
- Specifies the mode for cutter operation.
* This item is valid only for models
supporting both full cutting and partial
cutting.
89
Detail setup item
1µs
8µs
V-COM
PRINTER
ENABLE
DISABLE
AUTO
RECOVERY
RECOVERY BY
CMND
NORMAL
HI-SPEED
ENABLE
DISABLE
MODE 1
MODE 2
ENABLE
DISABLE
ENABLE
DISABLE
PARTIAL
FULL