Oki PT390 Manuel D'utilisation page 59

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 100
(4) DIP Switch
Note 1: This switch is maintenance use. Please use all switches by OFF
setting.
No.
1
2
3
4
Self Test for LAN Board
Initialization of settings
1) Turn off the printer.
2) Set the DIP Switch No.2 "ON".
3) Turn on the printer, and wait approximately 5 seconds until
completion of initialization.
4) Turn off the printer again.
5) Set the DIP Switch No.2 "OFF".
Self test print of settings
1) Turn off the printer.
2) Set the DIP Switch No.3 and No.4 "ON".
3) Turn on the printer, and Printer prints Self test.
4) Turn off the printer again.
5) Set the DIP Switch No.3 and No.4 "OFF".
Note: Be careful of handling DIP Switches.
ON
-
Settings Initialization
Settings Information
3
4
2
1
ON
57
OFF
Off (Fixed)
-
-
-

Publicité

Table des Matières
loading

Table des Matières