Appendix C: Special Modes; C-1.Test Printing - Oki PT390 Manuel D'utilisation

C-1.Test Printing

With paper inserted in the printer, turn off the printer power switch once, and
turn on the switch again while holding down the FEED switch on the control
panel. Then, the data shown below is printed. When "TEST PRINT" is printed,
press and hold down the FEED switch for one second or longer to start test
printing.
After printing a certain amount of data, the printer automatically cuts the
paper and ends the test printing. To terminate test printing in progress, press
the FEED switch. Then, the printer cuts the paper and terminates the test
printing.
Test printing
Sample test printout
PT390 Ver*.*
123456
POWER ON STATUS
RECEIVE BUFFER
BUSY CONDITION
RECEIVE ERROR
AUTO LF
DSR(#6) RESET

Appendix C: Special Modes

TEST PRINT
END
SAMPLE PRINT
CUTTER CLEANING
PLATEN ROLLER CLEAING
SET UP
HEX DUMP
TEST PRINT
SELECTION ITEM
ITEM SELECTION :FEED switch pushed short.
ITEM DECSION :FEED switch pushed short.
SPECIAL MODE
・
・
ENABLE
4K BYTE
BUFFERFULL
?PRINT
DISABLE
DISABLE
61