Oki PT390 Manuel D'utilisation page 80

Example (3): Setting required for using two-color thermal paper
Change of the print color setting (from monochrome to two colors)
The procedure for this setting is as follows.
1. Before starting work for this setting, verify the following conditions of the
printer:
(1) The power is off.
(2) Roll paper is inserted in it.
(3) The cover is closed.
2. Enter special mode.
Turn on the power switch on the right side of the printer while
holding down the FEED switch on the left part of the Top cover.
The printer prints the following when it enters special mode
TEST PRINT
END
SAMPLE PRINT
CUTTER CLEANING
PLATEN ROLLER CLEAING
SET UP
HEX DUMP
TEST PRINT
SELECTION ITEM
ITEM SELECTION :FEED switch pushed short.
ITEM DECSION :FEED switch pushed short.
SPECIAL MODE
78