Troubleshooting - Beurer EM 26 Mode D'emploi

Empty, completely flat batteries must be disposed of
through specially designated collection boxes, recycling
points or electronics retailers. You are legally required to
dispose of the batteries.
The codes below are printed on batteries containing harm-
ful substances:
Pb = Battery contains lead
Cd = Battery contains cadmium
Hg = Battery contains mercury

9. Troubleshooting

Problem Possible cause
The batteries are
The device
empty.
does not
The batteries are not
switch on.
inserted correctly.
Cuff is not in
sufficient contact
with the skin.
Stimulation
is too weak.
Water contact
electrodes are not
sufficiently moist.
Solution
Replace the
batteries.
Reinsert the
batteries.
Reposition the
cuff. Ensure there
is sufficient contact
with the skin.
Switch off the
device. Moisten
electrodes.
34
Problem Possible cause
The intensity on the
device is set too
high.
Water contact
electrodes are not
Stimulation
sufficiently moist.
is uncom-
fortable.
Connection cable is
worn/faulty.
Water contact
electrodes are worn/
faulty.
Irregular Connection cable
stimulation. faulty.
Water contact
Stimulation
electrodes are not
is
positioned correctly
ineffective.
on the skin.
Solution
Lower the intensity
on the device.
Switch off the
device. Moisten
electrodes.
Replace the
connection cable.
Replace the cuff.
Reduce the
intensity and rotate
the connection
cable at the socket
by 90°. If additional
power failures
occur, replace the
connection cable.
Remove water
contact electrodes
and reposition on
the skin. Ensure
there is sufficient
contact with the
skin.