Beurer EM 26 Mode D'emploi page 32

gradually in the new program until it reaches the intensity
that was previously set. This can be stopped if required by
pressing the intensity button ▼ [2] or by switching off the
device by pressing and holding the On/Off button [1] for
two seconds.
Stopping pulses that are too strong
You can lower the intensity at any time or turn the device
off by pressing and holding the On/Off button [1] (~ 2 sec-
onds).
Adjusting the intensity
Press the intensity button ▲ [2] to gradually increase the
intensity or the intensity button ▼ [2] to lower the intensity.
There are 20 levels of intensity that can be selected. De-
pending on the intensity level, you will start to feel tingling,
which may increase up to muscle contractions.
Select a setting that is comfortable for you during
use.
Preventing unwanted pulse changes
To prevent unintentional increases in intensity during a
treatment, simply switch the button lock on. To do this,
press and hold the program selection button P [3] for ap-
prox. 2 seconds. An acoustic signal sounds and the sym-
bol " " appears in the display [6]. To release the button
lock, press and hold the P button [3] for approx. 2 seconds.
Reacting to unpleasant sensations
If you feel a twinge or itching on your skin, you should
switch the device off and proceed as follows:
• Check that the electrodes are OK and do not show any
signs of damage.
• Check that the round cover is still on the electrode con-
nections.
• Remove the cuff and moisten it again completely.
• When you put it back on, ensure that there is good con-
tact with the skin and that the skin is damp.
Pausing a program
If you want to pause a program while it is running, briefly
press the Pause button [1]. An acoustic signal sounds and
the pause symbol "II" flashes in the display [6]. The pro-
gram can be continued by pressing the button [1] again.
Contact detection
If the electrodes are not in contact with the body, the inten-
sity will automatically be set to zero. This prevents unwant-
ed electrical stimulation. The intensity cannot be increased
if the electrodes are not in contact with the body.
Memory function
The device saves the last program that was set.
After replacing the battery, the device starts again with the
first program.
32