Preparation For Cutting - Efco DS 2200 Manuel D'utilisation Et D'entretien

Fuel Mixture
2-Cycle Engine Oil (25:1) 4%
Gasoline . . . . . . . . . . . . . . Oil
1 Gallon (US) . . . . . . . . . . 5.2 oz.
1 Liter . . . . . . . . . . . . . . . . 40 cc (40 ml)
2-Cycle Engine Oil (50:1) 2%
Gasoline . . . . . . . . . . . . . . Oil
1 Gallon (US) . . . . . . . . . . 2.6 oz.
1 Liter . . . . . . . . . . . . . . . . 20 cc (20 ml)
Filling the Tank
WARNING:
instruction
Always shut off engine before
fuelling. Never add fuel to a
machine with a running or hot
engine. Move at least 10 feet (3 m)
from refuelling site before starting
engine. DO NOT SMOKE!
1. Clean surface around fuel cap to prevent
contamination.
2. Loosen fuel cap slowly.
3. Carefully pour fuel mixture into the tank.
Avoid spillage.
4. Prior to replacing the fuel cap, clean and
inspect the gasket.
5. Immediately replace fuel cap and hand
tighten. Wipe up any fuel spillage.
WARNING: Check for fuel leaks,
if any are found, correct before
use. Contact a Servicing Dealer if
necessary.
OPERATION
Follow safety
for fuel handling.

Preparation for Cutting

WARNING: To use the blades with
the brush cutters DS 2200 S and
DS 2400 S must be purchased the
kit p.n. 61370224.
WARNING:
blades (only S and T models),
avoid cutting close to fences,
sides of buildings, tree trunks,
stones or other such objects that
could cause the brush cutter to
kick out or could cause damage
to the blade. We recommends use
of the nylon line heads for such
jobs. In addition, be alert to an
increased possibility of ricochets
in such situations.
WARNING: The brush cutter is
normally to be used at ground
level with the cutting attachment
parallel to the ground. Use of a
brush cutter above ground level
or with the cutting attachment
perpendicular to the ground may
increase the risk of injury, since
the cutting attachment is more
fully exposed and the brush cutter
may be more difficult to control.
Never use your brush cutter as a
hedge trimmer.
WARNING: If the blade loosens
after being properly tightened,
stop work
retaining nut may be worn or
damaged and should be replaced.
Never use unauthorized parts
to secure the blade. If the blade
continues to loosen, see your
dealer. Never use a brush cutter
with a loose blade.
Basic Cutting Procedure
1. Wear non-slip gloves for maximum grip
and protection.
When using rigid
immediately. The
en
17