Efco DS 2200 Manuel D'utilisation Et D'entretien page 17

WARNING:
attachments with the guards we
recommend! See the chapter on
Recommended cutting attachments
en
(Page 10). Refer to the instructions for
the cutting attachment to check the
correct way to load the cord and the
correct cord diameter. Keep the teeth
of the blade correctly sharpened!
Follow our recommendations. Also
refer to the instructions on the blade
packaging. Maintain the correct blade
setting! Follow our instructions.
WARNING: Always stop the engine
before doing any work on the
cutting attachment. The attachment
continues to rotate even after the
throttle has been released. Ensure
that the cutting attachment has
stopped completely and disconnect
the HT lead from the spark plug
before you start to work on it.
WARNING:
cutting attachment or an incorrectly
sharpened blade increases the risk of
kickout.
WARNING: Always discard a blade
that is bent, twisted, cracked, broken
or damaged in any other way. Never
attempt to straighten a twisted blade
so that it can be reused. Only use
original blades of the specified type.
WARNING:
of serious injury, never use wire
or metal-reinforced line or other
material in place of the nylon cutting
lines. Pieces of wire could break off
and be thrown at high speed toward
the operator or bystanders.
Assembling
(Fig.27)
Insert the upper flange (F) and washer (A).
Screw the head counterclockwise by hand. To
take it apart, put the head fixing pin into the
appropriate hole (L) and unscrew clockwise.
14
Only use cutting
Using an incorrect
To reduce the
trimmer head
ASSEMBLY
Assembling trimmer head (S-T) (Fig.8)
For dismantling the trimmer head (C), put the
head fixing pin (A) in the appropriate hole (B) and
loosen the head clockwise by hand.
For assembling the head (C), reverse the
sequence described after put the upper flange (F)
in place.
Assembling
machines with bent drive shaft-TR) (Fig. 9)
WARNING - To use the blades with the brush
cutters DS 2200 S and DS 2400 S must be
purchased the kit p.n. 61370224 which comprises:
1) cutting attachment guard (to fit in place of that
supplied)
2) safety boom (to be mounted under the loop
handle)
3) blade
4) lower flange
5) cup
6) nut
Remove the skirt (C, Fig.7) from the cutting
attachment guard (A) before assembling the
blade.
Fix the blade (R) onto the upper flange (F) making
sure that the rotation direction is correct.
WARNING:
C, Fig.9) must locate in blade's
mounting hole.
Fix the lower flange (E), the cup (B) and tighten
nut (A) anti-clockwise.
Put the pin provided in the appropriate hole (L)
to block the blade and allow the nut (A) to be
tightened to 18 ft lb (25 Nm).
Assembling the safety boom (DS 2200 S - DS
risk
2400 S) (Fig. 9A)
When using the disc instead of nylon line head,
it is necessary to set up the "safety boom". Fix
the boom (A) under the attachment (C) of handle
(20B, Fig. 1) by means of the screws (B). Taking
care to verify the "safety boom" being on the left
side of the brushcutter.
(TR)
WARNING: Arrows on the cutting
attachment guard show the correct
direction of rotation of the cutting
tool.
the blade
(excluding
Collar (see arrows