Preparation For Cutting - Efco 8245 SE Manuel D'utilisation Et D'entretien

en
14
OPERATION
Fuel Mixture
23
2-Cycle Engine Oil (25:1) 4%
Gasoline
1 Gallon (US) . . . . . . . . . . . . . . . . . . . . . . . . . . 5.2 oz.
1 Liter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 cc (40 ml)
2-Cycle Engine Oil (50:1) 2%
Gasoline
1 Gallon (US) . . . . . . . . . . . . . . . . . . . . . . . . . . 2.6 oz.
1 Liter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 cc (20 ml)
Filling the Tank
WARNING: Follow safety instruction for fuel
handling. Always shut off engine before fuelling.
Never add fuel to a machine with a running or hot
engine. Move at least 10 feet (3 m) from refuelling
site before starting engine (Fig. 23). DO NOT
SMOKE!
1. Clean surface around fuel cap to prevent contamination.
2. Loosen fuel cap slowly.
3. Carefully pour fuel mixture into the tank. Avoid spillage.
4. Prior to replacing the fuel cap, clean and inspect the gasket.
5. Immediately replace fuel cap and hand tighten. Wipe up any
fuel spillage.
WARNING: Check for fuel leaks, if any are found,
correct before use. Contact a Servicing Dealer if
necessary.

Preparation for Cutting

The stick edger is designed for edging lawn in gardens, parks,
roadsides and so on.
Before starting the engine, take the operating position and adjust
24
the wheel height as necessary.
Adjusting Wheel Height
1. Loosen the wing nut and change the wheel height to obtain
desired cutting depth (Fig. 24).
(1) Deep cut
(2) Shallow cut
(3) Wing nut
2. After adjusting the height, tighten the wing nut securely.
Tightening Torque: 4.5-6 ftlb (6-8 Nm).
WARNING - Never adjust wheel height with the
engine running.
Oil
Oil